ERA12LA574 · Cessna 150G
Cessna 150G · Accident: loss of engine power (total) en route
From Silver Comet Field at Paulding Northwest Atlanta Airport (PUJ) to MO1 · Memphis, TN
Narrative check · The NTSB narrative appears to contradict this record's departure or destination. Values are shown as recorded, not corrected; compare with the narrative.
Event
- NTSB case
- ERA12LA574
- Event typeAccident: someone killed or seriously injured, or the aircraft substantially damaged (NTSB definition). Incident: an occurrence that affected or could have affected safety, short of that. Glossary
- Accident
- InvestigationHow far the investigation had got when the record was published: preliminary, ongoing, final or completed. Unknown where the source does not say. Glossary
- Completed
- API-reported fatalities
- 0 · all aircraft and ground
- Ground fatalities
- Unknown
- OperationWhat kind of flying it was, grouped by the rules it flew under: airline (US Part 121), air taxi and commuter (Part 135), general aviation (Part 91 and similar), military or government. Glossary
- General aviation
- WeatherVisual meteorological conditions (VMC): good enough to fly by looking outside. Instrument conditions (IMC): cloud or low visibility, flying by instruments. Glossary
- Visual Meteorological Cond
Cessna 150G
- Aircraft type
- Cessna 150
- Category
- Airplane
- RegistrationThe aircraft's tail number, such as N12345 or G-ABCD. Registrations are reissued, so the same one years apart can be a different aircraft. Glossary
- N8465J
- Operator
- Ronald Noland
- Onboard fatalities
- Unknown
- Route Narrative disagrees
- From Silver Comet Field at Paulding Northwest Atlanta Airport (PUJ), Paulding NW ATL, GATo MO1 · Memphis, TN
- Aircraft age
- Not recorded
- Flight rulesThe regulations the flight operated under: in the US, Part 91 (general aviation), Part 121 (airlines), Part 135 (air taxi and commuter) and others; for flights abroad, the NTSB's coarser commercial or non-commercial code. Glossary
- Part 91: General Aviation
- Phase of flightThe stage of the flight when things started to go wrong: standing, taxi, takeoff, initial climb, en route, maneuvering, approach or landing. Glossary
- En route · cruise
- Defining eventThe single coded event the NTSB judges best describes what happened (records from 2008 on). Older records name the first occurrence in the sequence instead. Glossary
- Loss of engine power (total)
- DamageDestroyed: beyond practical repair. Substantial: damage that affects the structure, performance or handling and normally needs major repair. Minor: less than that. Glossary
- Substantial
Cause areas
- Aircraft › Aircraft power plant
- Personnel issues › Task performance
Approximate · Coordinates as recorded by the NTSB; no uncertainty radius is established.
NTSB narrative
According to the pilot, after about 2 hours of uneventful flight, a loud noise came from the engine compartment, the engine cowling shook violently, and the engine experienced a total loss of power. During the subsequent descent, the pilot attempted to restart the engine. The propeller continued to windmill, but the engine did not restart. The pilot selected a field for a forced landing, and during the landing roll, the landing gear became entangled with the crop. The airplane then nosed over and came to rest inverted, and the pilot and his wife egressed with minor injuries.
Examination of the engine revealed that the crankshaft gear bolt locking tab washer and the alignment dowel for the gear mounting flange were fractured due to fatigue. This allowed the gear to rotate on the crankshaft. The fatigue resulted from improper torque application on the crankshaft gear bolt during overhaul, which had been completed 26 years and 643 total airplane flight hours before the accident. In service bulletins and service instructions, the engine manufacturer warned that improper installation of the crankshaft gear may result in "complete engine stoppage" and recommended that engines be overhauled after 12 years in service, even if the engine had not accumulated the manufacturer-specified 2,000-hour time-between-overhaul during that period.
Probable cause
The improper torque application on the crankshaft gear bolt by maintenance personnel during an engine overhaul, which resulted in the fatigue failure of the locking tab washer and gear alignment dowel and subsequent engine stoppage. Contributing to the accident was the operator’s exceedence of the engine overhaul calendar year limits recommended by the engine manufacturer.
Verbatim NTSB analysis and probable cause from the NTSB dataset
Sources
NTSB record ERA12LA574
- Event ID
- 20120922X32829
- Case number
- ERA12LA574
- Dataset
- full-current
- Source SHA-256
- 5cf380f0061817c0331a6b2d8cc7e0ee3a79bea469a1001dc5c10e56f35f5ab3
Source notes (4)
- Unreviewed is an editorial label, not an investigation status. API-sourced is not report-checked or human-reviewed. Explicit event totals are used without summing aircraft injury tables; onboard allocation is withheld. Unknown values remain unknown. The operation category is mapped from the NTSB-reported FAR part and has not been reviewed.
- Filled from the NTSB case API where the bulk record had no value: investigation status. Values present in the bulk record are kept.
- The date is the local date, which is the same as the UTC date the NTSB stores.
- API snapshot SHA-256: cd4539cef78002b47b89618a5395ecd896e0c3f275cf29d4d0d2e49b59a5d95c; retrieved 2026-09-15T20:00:00.262Z.