CHI02FA231 · Piper PA-46-350P
Piper PA-46-350P · Accident: total loss of engine power (mechanical failure) en route
From Sioux Falls Regional Airport (FSD) to Southwest Michigan Regional Airport (BEH)
Event
- NTSB case
- CHI02FA231
- Event typeAccident: someone killed or seriously injured, or the aircraft substantially damaged (NTSB definition). Incident: an occurrence that affected or could have affected safety, short of that. Glossary
- Accident
- InvestigationHow far the investigation had got when the record was published: preliminary, ongoing, final or completed. Unknown where the source does not say. Glossary
- Completed
- API-reported fatalities
- 3 · all aircraft and ground
- Ground fatalities
- Unknown
- OperationWhat kind of flying it was, grouped by the rules it flew under: airline (US Part 121), air taxi and commuter (Part 135), general aviation (Part 91 and similar), military or government. Glossary
- General aviation
- WeatherVisual meteorological conditions (VMC): good enough to fly by looking outside. Instrument conditions (IMC): cloud or low visibility, flying by instruments. Glossary
- Visual Meteorological Cond
Piper PA-46-350P
- Aircraft type
- Piper PA-46
- Category
- Airplane
- RegistrationThe aircraft's tail number, such as N12345 or G-ABCD. Registrations are reissued, so the same one years apart can be a different aircraft. Glossary
- N316PM
- Operator
- Unknown
- Onboard fatalities
- Unknown
- Route
- From Sioux Falls Regional Airport (FSD), Sioux Falls, SDTo Southwest Michigan Regional Airport (BEH), Benton Harbor, MI
- Aircraft age
- Not recorded
- Flight rulesThe regulations the flight operated under: in the US, Part 91 (general aviation), Part 121 (airlines), Part 135 (air taxi and commuter) and others; for flights abroad, the NTSB's coarser commercial or non-commercial code. Glossary
- Part 91: General Aviation
- Phase of flightThe stage of the flight when things started to go wrong: standing, taxi, takeoff, initial climb, en route, maneuvering, approach or landing. Glossary
- En route · cruise
- First occurrenceThe single coded event the NTSB judges best describes what happened (records from 2008 on). Older records name the first occurrence in the sequence instead. Glossary
- Total loss of engine power (mechanical failure)
- Also codedOther events the NTSB coded in the sequence, such as a wire strike after a loss of power. Flight Findings uses them for its kinds of event. Glossary
- Stall/spin
- DamageDestroyed: beyond practical repair. Substantial: damage that affects the structure, performance or handling and normally needs major repair. Minor: less than that. Glossary
- Substantial
Cause areas
- Pilot in command › Airspeed, not maintained
- Pilot in command › Proper glidepath, not maintained
Approximate · Coordinates from the NTSB case API, which marks them as estimated or does not say; no uncertainty radius is established.
NTSB narrative
The single-engine airplane experienced a loss of engine power during cruise flight at flight level 190 (19,000 feet) and impacted the terrain while performing a forced landing to a nearby airport. Visual meteorological conditions prevailed at the time of the accident with clear skies and unrestricted visibilities. The pilot reported the loss of engine power about 16 minutes prior to the accident and requested clearance to the nearest airport. Air traffic control (ATC) issued vectors to the Southwest Michigan Regional Airport (BEH). About 10 minutes prior to the accident, the airplane was positioned approximately 1.3 nm north of BEH at 13,500 feet. The pilot elected to follow ATC vectors verses circling down over BEH. ATC provided vectors for runway 27 at BEH. Witnesses to the accident reported seeing the airplane "spiraling down and crashing into the ground." The wreckage was located on the extended runway 27 centerline, about 1.12 nm from the runway threshold. The distribution of the wreckage was consistent with a stall/spin accident. Approximately four minutes before the accident, the airplane was on a 9.5 nm final approach at 6,700 feet. Between 9.5 and 5.3 nm the airspeed fluctuated between 119 and 155 knots, and the descent rate varied between 1,550 and 2,600 feet/min. Between 5.3 nm and the last radar return at 1.5 nm the airspeed dropped from 155 to 78 knots. According to the Pilot Operating Handbook (POH) the accident airplane should be flown at best glide speed (92 knots) after a loss of engine power. An average engine-out descent rate of 700 feet/min is achieved when best glide speed is maintained during engine-out descents. An engine teardown inspection revealed that the crankshaft was fractured at the number five crankpin journal. Visual examination of the crankshaft (p/n 13F27738, s/n V537920968) showed a fatigue-type fracture through the cheek, aft of the number five crankpin journal. The exact cause of the crankshaft failure could not be determined, due to mechanical damage at the fatigue initiation point. The fracture features for the accident crankshaft was consistent with 14 previous failures of the same part number. The engine manufacturer determined the failures were most likely due to the overheating of the steel during the forging process.
Probable cause
The pilot's failure to maintain airspeed above stall speed resulting in a stall/spin. Additional causes were the pilot not maintaining best glide airspeed and optimal glidepath following the loss of engine power. A factor to the accident was the engine failure due to the fatigue failure of the crankshaft.
Verbatim NTSB analysis and probable cause from the NTSB dataset
Sources
NTSB record CHI02FA231
- Event ID
- 20020808X01353
- Case number
- CHI02FA231
- Dataset
- historical-pre2008
- Source SHA-256
- 89e2df6d848e7ab3b42e7d7c7a03ff403303057a26ca04c95b3ea67201c3ce74
Source notes (4)
- Unreviewed is an editorial label, not an investigation status. API-sourced is not report-checked or human-reviewed. Explicit event totals are used without summing aircraft injury tables; onboard allocation is withheld. Unknown values remain unknown. The operation category is mapped from the NTSB-reported FAR part and has not been reviewed.
- Filled from the NTSB case API where the bulk record had no value: investigation status, coordinates. Values present in the bulk record are kept.
- The date is the local date, which is the same as the UTC date the NTSB stores.
- API snapshot SHA-256: 27358605494862ea13043c65b34be3d2ab04cce267ba5537c823c3bb1c6dbb83; retrieved 2026-09-20T19:55:41.926Z.