FLIGHT FINDINGSAVIATION OCCURRENCE MAP
Back to map

ANC18LA019 · Cessna 210 C

14 Jan 2018 · Juneau, AK, United States

Cessna 210 C · Accident: landing gear collapse

From Hoonah Airport (HNH) to an unrecorded destination

Report a problem

Event

NTSB case
ANC18LA019
Event typeAccident: someone killed or seriously injured, or the aircraft substantially damaged (NTSB definition). Incident: an occurrence that affected or could have affected safety, short of that. Glossary
Accident
InvestigationHow far the investigation had got when the record was published: preliminary, ongoing, final or completed. Unknown where the source does not say. Glossary
Completed
API-reported fatalities
0 · all aircraft and ground
Ground fatalities
Unknown
OperationWhat kind of flying it was, grouped by the rules it flew under: airline (US Part 121), air taxi and commuter (Part 135), general aviation (Part 91 and similar), military or government. Glossary
General aviation
WeatherVisual meteorological conditions (VMC): good enough to fly by looking outside. Instrument conditions (IMC): cloud or low visibility, flying by instruments. Glossary
Visual Meteorological Cond

Cessna 210 C

Aircraft type
Cessna 210
Category
Airplane
RegistrationThe aircraft's tail number, such as N12345 or G-ABCD. Registrations are reissued, so the same one years apart can be a different aircraft. Glossary
N3607Y
Operator
Unknown
Onboard fatalities
Unknown
Route
From Hoonah Airport (HNH), Hoonah, AKTo not recorded
Aircraft age
About 56 years (built 1962)
Flight rulesThe regulations the flight operated under: in the US, Part 91 (general aviation), Part 121 (airlines), Part 135 (air taxi and commuter) and others; for flights abroad, the NTSB's coarser commercial or non-commercial code. Glossary
Part 91: General Aviation
Phase of flightThe stage of the flight when things started to go wrong: standing, taxi, takeoff, initial climb, en route, maneuvering, approach or landing. Glossary
Landing · landing roll
Defining eventThe single coded event the NTSB judges best describes what happened (records from 2008 on). Older records name the first occurrence in the sequence instead. Glossary
Landing gear collapse
DamageDestroyed: beyond practical repair. Substantial: damage that affects the structure, performance or handling and normally needs major repair. Minor: less than that. Glossary
Substantial

Cause areas

  • Aircraft › Aircraft systems
  • Aircraft › Fluids/miscellaneous hardware

Approximate · Coordinates as recorded by the NTSB; no uncertainty radius is established.

NTSB narrative

The pilot extended the landing gear as the airplane neared the destination airport. The nose gear fully extended and locked into place, but the left and right main landing gear only partially extended. The pilot attempted to manually extend the main landing gear; however, all hydraulic pressure was lost and the gear did not extend fully. He subsequently landed the airplane, during which the main landing gear collapsed, resulting in substantial damage to the right wing and horizontal stabilizer. Examination of the hydraulic system revealed that the right main landing gear hydraulic actuator was fractured about the barrel section adjacent to the end cap. A fracture at the retainer clip groove exhibited striations consistent with fatigue crack propagation, and other fractures through the barrel exhibited signatures of overstress failure. It is likely that, once the fatigue crack grew to a significant depth, the housing cracked further from overstress and hydraulic fluid leaked out of the system, preventing the landing gear from descending properly. The airplane experienced a landing gear collapse accident three years prior that was caused by the left landing gear actuator failure due to a fatigue crack at the retainer ring recess, similar to this accident. The manufacturer had previously issued instructions for modification of some landing gear hydraulic actuators installed on the accident airplane make and model, and a Federal Aviation Administration airworthiness directive (AD) was subsequently issued to mandate the modifications. The manufacturer had also issued a service letter for enhanced inspection of the landing gear actuators. The maintenance records available were insufficient to determine whether the accident airplane had been maintained in accordance with the AD and manufacturer instructions.

Probable cause

A loss of hydraulic fluid due to a fatigue failure of the right main landing gear hydraulic actuator, which resulted in the pilot's inability to fully extend the landing gear and a main landing gear collapse during the landing roll.

Verbatim NTSB analysis and probable cause from the NTSB dataset

Sources

NTSB record ANC18LA019
Event ID
20180115X64043
Case number
ANC18LA019
Dataset
full-current
Source SHA-256
5cf380f0061817c0331a6b2d8cc7e0ee3a79bea469a1001dc5c10e56f35f5ab3
Source notes (4)
  • Unreviewed is an editorial label, not an investigation status. API-sourced is not report-checked or human-reviewed. Explicit event totals are used without summing aircraft injury tables; onboard allocation is withheld. Unknown values remain unknown. The operation category is mapped from the NTSB-reported FAR part and has not been reviewed.
  • Filled from the NTSB case API where the bulk record had no value: investigation status, cause areas. Values present in the bulk record are kept.
  • The date is the local date, which is the same as the UTC date the NTSB stores.
  • API snapshot SHA-256: faf6cb39faec65e59462ef4466306ee8cde2e4b4ae504bee0cfbd3690ee99eed; retrieved 2026-09-16T06:18:29.011Z.