ANC18LA008 · Cloud Jeffrey Ferrell LONG EZ
Cloud Jeffrey Ferrell LONG EZ · Accident: part(s) separation from aircraft en route
From Marianna Municipal Airport (MAI) to Peachtree City Falcon Field (FFC)
Event
- NTSB case
- ANC18LA008
- Event typeAccident: someone killed or seriously injured, or the aircraft substantially damaged (NTSB definition). Incident: an occurrence that affected or could have affected safety, short of that. Glossary
- Accident
- InvestigationHow far the investigation had got when the record was published: preliminary, ongoing, final or completed. Unknown where the source does not say. Glossary
- Completed
- API-reported fatalities
- 0 · all aircraft and ground
- Ground fatalities
- Unknown
- OperationWhat kind of flying it was, grouped by the rules it flew under: airline (US Part 121), air taxi and commuter (Part 135), general aviation (Part 91 and similar), military or government. Glossary
- General aviation
- WeatherVisual meteorological conditions (VMC): good enough to fly by looking outside. Instrument conditions (IMC): cloud or low visibility, flying by instruments. Glossary
- Visual Meteorological Cond
Cloud Jeffrey Ferrell LONG EZ
- Aircraft type
- Cloud Jeffrey Ferrell LONG EZ
- Category
- Airplane
- RegistrationThe aircraft's tail number, such as N12345 or G-ABCD. Registrations are reissued, so the same one years apart can be a different aircraft. Glossary
- N754T
- Operator
- Unknown
- Onboard fatalities
- Unknown
- Route
- From Marianna Municipal Airport (MAI), Marianna, FLTo Peachtree City Falcon Field (FFC), Atlanta, GA
- Aircraft age
- About 2 years (built 2015)
- Flight rulesThe regulations the flight operated under: in the US, Part 91 (general aviation), Part 121 (airlines), Part 135 (air taxi and commuter) and others; for flights abroad, the NTSB's coarser commercial or non-commercial code. Glossary
- Part 91: General Aviation
- Phase of flightThe stage of the flight when things started to go wrong: standing, taxi, takeoff, initial climb, en route, maneuvering, approach or landing. Glossary
- En route
- Defining eventThe single coded event the NTSB judges best describes what happened (records from 2008 on). Older records name the first occurrence in the sequence instead. Glossary
- Part(s) separation from aircraft
- DamageDestroyed: beyond practical repair. Substantial: damage that affects the structure, performance or handling and normally needs major repair. Minor: less than that. Glossary
- Substantial
Cause areas
- Aircraft › Aircraft propeller/rotor
Approximate · Coordinates from the NTSB case API, which marks them as estimated or does not say; no uncertainty radius is established.
NTSB narrative
The private pilot was conducting a personal flight in an experimental airplane. While in cruise flight, the airplane "violently began shuddering," and the pilot immediately shut down the engine and attempted an emergency landing. The airplane was unable to reach the selected runway and landed about 200 ft short of the runway threshold in a rough, grassy area. After exiting the airplane, the pilot discovered that a portion of the trailing edge of the wood propeller had separated and penetrated the lower half of the right rudder control surface.
A postaccident examination of the remaining portion of the wood propeller determined that the propeller was manufactured from laminations of defect-free hard maple lumber that showed no signs of decay. An inspection of the separation surface indicated that the individual layers of the propeller were laminated together using an adhesive that resulted in a light-colored bond line. The failure surface included an exposed portion of the bond line between two wood layers that had failed. Examination of this bond line showed minimal wood failure that was about 8 inches long and between 1/8 and 1/4 inch wide. The amount of cured adhesive observed varied considerably along the length of the failure surface's bond line, with an area of the bond line having minimal adhesive coverage.
According to the propeller manufacturer, the propeller was carved by hand and assembled using an adhesive that is advertised as "ideal for interior wood application." However, the adhesive had not been tested for applications in which extreme temperature fluctuations, pressure, and vibrations would be expected, such as those experienced during airplane operations.
Probable cause
The in-flight separation of a portion of the propeller, which subsequently penetrated the right rudder, as a result of the failure of the bond line between two of the propeller’s wood layers. Contributing to the failure of the propeller was the manufacturer’s use of an inappropriate bonding agent.
Verbatim NTSB analysis and probable cause from the NTSB dataset
Sources
NTSB record ANC18LA008
- Event ID
- 20171113X84023
- Case number
- ANC18LA008
- Dataset
- full-current
- Source SHA-256
- 5cf380f0061817c0331a6b2d8cc7e0ee3a79bea469a1001dc5c10e56f35f5ab3
Source notes (4)
- Unreviewed is an editorial label, not an investigation status. API-sourced is not report-checked or human-reviewed. Explicit event totals are used without summing aircraft injury tables; onboard allocation is withheld. Unknown values remain unknown. The operation category is mapped from the NTSB-reported FAR part and has not been reviewed.
- Filled from the NTSB case API where the bulk record had no value: investigation status, coordinates. Values present in the bulk record are kept.
- The date is the local date, which is the same as the UTC date the NTSB stores.
- API snapshot SHA-256: 7d8e92d5e6ec1b58a32e79f3498872d4a28628324c3257152b1eab95241a6842; retrieved 2026-09-16T06:00:01.789Z.