FTW03LA066 · Hughes 369E
Hughes 369E · Accident: partial loss of engine power (mechanical failure) en route
From Syracuse, KS (no airport) to Gruver, TX (no airport)
Event
- NTSB case
- FTW03LA066
- Event typeAccident: someone killed or seriously injured, or the aircraft substantially damaged (NTSB definition). Incident: an occurrence that affected or could have affected safety, short of that. Glossary
- Accident
- InvestigationHow far the investigation had got when the record was published: preliminary, ongoing, final or completed. Unknown where the source does not say. Glossary
- Completed
- API-reported fatalities
- 0 · all aircraft and ground
- Ground fatalities
- Unknown
- OperationWhat kind of flying it was, grouped by the rules it flew under: airline (US Part 121), air taxi and commuter (Part 135), general aviation (Part 91 and similar), military or government. Glossary
- General aviation
- WeatherVisual meteorological conditions (VMC): good enough to fly by looking outside. Instrument conditions (IMC): cloud or low visibility, flying by instruments. Glossary
- Visual Meteorological Cond
Hughes 369E
- Aircraft type
- Hughes 369
- Category
- Helicopter
- RegistrationThe aircraft's tail number, such as N12345 or G-ABCD. Registrations are reissued, so the same one years apart can be a different aircraft. Glossary
- N5234Y
- Operator
- Unknown
- Onboard fatalities
- Unknown
- Route
- From Syracuse, KS (no airport)To Gruver, TX (no airport)
- Aircraft age
- Not recorded
- Flight rulesThe regulations the flight operated under: in the US, Part 91 (general aviation), Part 121 (airlines), Part 135 (air taxi and commuter) and others; for flights abroad, the NTSB's coarser commercial or non-commercial code. Glossary
- Part 91: General Aviation
- Phase of flightThe stage of the flight when things started to go wrong: standing, taxi, takeoff, initial climb, en route, maneuvering, approach or landing. Glossary
- En route · cruise
- First occurrenceThe single coded event the NTSB judges best describes what happened (records from 2008 on). Older records name the first occurrence in the sequence instead. Glossary
- Partial loss of engine power (mechanical failure)
- DamageDestroyed: beyond practical repair. Substantial: damage that affects the structure, performance or handling and normally needs major repair. Minor: less than that. Glossary
- Substantial
Cause areas
- Electrical system, generator › Failure
- Fuel system, pc line › Fatigue
- Fuel system, pc line › Fractured
Approximate · Coordinates from the NTSB case API, which marks them as estimated or does not say; no uncertainty radius is established.
NTSB narrative
The helicopter was damaged during a forced landing after a loss of engine power while in cruise flight. The 14,700-hour pilot stated that at 5,100 feet MSL, the generator warning light illuminated. The pilot switched the generator "OFF" and back "ON" in an attempt to reset it, and was unable to reset the generator. The pilot then recycled the circuit breaker to try to reset the generator, and was still unable to reset the generator. The pilot pulled the generator circuit breaker and aborted the flight. Approximately 15 minutes after the generator failure, the engine out light illuminated and an audio warning came on, engine and rotor RPM started to decay and the pilot initiated autorotation. The auto re-ignition light illuminated during autorotation, but the engine would not spool back up to normal RPM. The pilot continued with the autorotation to a small clearing. During the final phase of the autorotation the pilot performed a cyclic flare to increase rotor RPM and arrest forward movement. The pilot leveled the helicopter a few feet off the ground and pulled the collective to arrest descent, at that point rotor RPM decayed and the helicopter dropped four feet AGL. The helicopter spun approximately 180 degrees from the original heading and impacted the ground nose first, on a heading of 30 degrees. Examination of the generator revealed that its drive-end bearing had failed. Bearing cage pieces fell out during disassembly. A Pc air leak test was performed and a air was detected emanating from the Pc air tube from the power turbine governor (PTG) to the engine fuel control unit (FCU). The tube was fractured approximately 90% circumferentially just above the coupling nut that attaches the tube to the FCU. A new Pc air tube (same part number) was installed and the engine was operated in a test cell. The engine was operated in accordance with the model 250-C20B Production Test Specifications. With the engine in the standard test configuration, response times were within normal limits and the engine met all performance parameters. Further metallurgical examination of the Pc tube revealed evidence of fatigue.
Probable cause
The loss of engine power due to the failure of the generator input drive-end bearing, which resulted in excessive vibrations that induced a fatigue fracture of the Pc line leading to the engine fuel control unit. A contributing factor was the lack of suitable terrain for the forced landing.
Verbatim NTSB analysis and probable cause from the NTSB dataset
Sources
NTSB record FTW03LA066
- Event ID
- 20030130X00134
- Case number
- FTW03LA066
- Dataset
- historical-pre2008
- Source SHA-256
- 89e2df6d848e7ab3b42e7d7c7a03ff403303057a26ca04c95b3ea67201c3ce74
Source notes (4)
- Unreviewed is an editorial label, not an investigation status. API-sourced is not report-checked or human-reviewed. Explicit event totals are used without summing aircraft injury tables; onboard allocation is withheld. Unknown values remain unknown. The operation category is mapped from the NTSB-reported FAR part and has not been reviewed.
- Filled from the NTSB case API where the bulk record had no value: investigation status, coordinates. Values present in the bulk record are kept.
- The date is the local date, which is the same as the UTC date the NTSB stores.
- API snapshot SHA-256: a07e8e3a39a83dfa7faa151ce08b112412e25723ad557d126d75f2566d75c2e3; retrieved 2026-09-22T09:47:06.484Z.